So you just graduated school and are looking to get some of the hvac tools to start of your career.
I've seen many posts about the HVAC tools lists and lots of them leave out tools that in my opinion will make your easier.
So to be as accurate as possible I took picture of my most used HVAC tools that I think would be valuable to technician..
It should have Phillips bit, Flathead bit sizes #1 and #2, 1 4″, 5 16″ and 3 8# driver as well.
The common type of driver you will be using as service or technician will be 1 4″, 5 16″ and 3 8″.
For entry level tech learning on the hvac training you can get away with size that will cut as small as 1 4″ up to 1″ 2.
Your meter should also be RMS and best hvac tools when testing voltage and amps on equipment..
I like to have the wire type and the tool as there are situations where the handheld pvc cutters wont work if drain line is too close to wall..
This is the HVAC tools list that I can come up with, and I own all of these took me couple of years to get them all.
I suggest that you drop them little bit.
Read more